Sscnet Communication Drivers; Sscnet Communication Driver Setup Procedure - Mitsubishi Electric MELSEC System Q Installation Manual

4. SSCNET COMMUNICATION DRIVERS

4. SSCNET COMMUNICATION DRIVERS
4.1

SSCNET Communication Driver Setup Procedure

To make SSCNET communication in Windows NT/98, you need to perform
SSCNET communication driver setup.
Perform the setup work of the SSCNET communication drivers in the [SSCNET
Communication Driver Setup] window of SNETP.
POINT
(1) You need not set the driver when you do not fit the interface card or
interface board to the personal computer as described below.
Always click [Cancel] in the "SSCNET Communication Driver Setup"
window.
• When only RS232C communication is used
• When SSCNET communication is not used
(When only the offline function for program edit, etc. is used)
• When there is no interface card or interface board
(2) In either of the following cases, an SSCNET communication driver setup
is not performed because of compatibility with the plug and play function.
• When the A30CD-PCF interface card and the A10CD-PCF interface
board is used in the Windows 2000 environment.
(3) The interface boards and interface cards can be used in the following
environment.
A30BD-PCF interface board
A10BD-PCF interface board
A30CD-PCF interface board
1) Choose and click [Programs]-[SWnRNC-GSVE]-
[SW3RNC-GSVE]-[SW3RN-SNETP]-[SSCNET
Communication Driver Setup] in the Start menu.
The following Communication Driver Setup window
appears.
Choose "A30CD-PCF Card Type" when using the
A30CD-PCF interface card, or choose "A30BD-PCF
Board Type" when using the A30BD-PCF interface
board, or choose "A10BD-PCF Board Type" when
using the A10BD-PCF interface board.
Hereafter, the A30CD-PCF interface card is
represented as the "interface card" and the A30BD-
PCF interface board and the A10BD-PCF interface
board as the "interface board".
Windows 98 Windows NT
4 − 1
Windows 2000
Usable:
Unusable: