Mitsubishi Electric MELSEC System Q Installation Manual page 26

3. INSTALLATION AND UNINSTALLATION
From preceding page
To next page
15) Type the program folder name to be registered to
the start menu.
The default program folder names to be registered
are as follows.
• SWnRNC-GSV
When not changing, click [Next >].
When changing, type a new program folder name
and click [Next >].
16) The dialog box shown on the left appears if the
SSCNET communication driver or SNETP is not
installed or SW6RN-SNETP Version 00B or later
coexists with SW3RN-SNETP Ver. 00N or earlier.
The SSCNET communication driver must be set up.
After termination of the setup, set the SSCNET
driver.
In any of the following cases, the dialog box shown
on the left does not appear. You need not set up
the SSCNET communication driver.
• SW3RN-SNETP Ver. 00P or later is already
installed
• The SSCNET communication driver is already
installed
• In the setup method given in step 14), "Custom"
is selected and "SSCNET application" is not
selected
(Since the SSCNET communication driver is not
installed, setting is also unnecessary.)
*: This dialog box don't appear in Windows 2000.
17) Installation starts.
18) When SNETP is installed after the selection of
"Standard" or "SSCNET application" in "Custom", the
installation of the SSCNET communication driver
starts.
3 − 6