CHAPTER 9
This chapter describes how to check the location and the cause of an error which has occurred in the network with
SSCNET III Communication Condition Monitor of MT Developer2.
Connect MT Developer2 to the Motion controller to check the connection status of servo amplifiers and head modules
on SSCNET III/H.
(1) Starting the SSCNET III Communication Condition Monitor
This section describes how to start the SSCNET III Communication Condition Monitor.
1.
Connect MT Developer2 to the Motion controller.
2.
Start the SSCNET III Communication Condition Monitor from the menu of MT Developer2.
[Online] [Monitor] [SSCNET III Communication Condition Monitor]
CHAPTER 9 SSCNET III COMMUNICATION CONDITION MONITOR
SSCNET III COMMUNICATION
CONDITION MONITOR
9
77