Mitsubishi Electric MELSEC System Q Installation Manual page 77

4. SSCNET COMMUNICATION DRIVERS
From preceding page
(8) Adjusting the CH. 0 cyclic driver
Adjust the CH. 0 cyclic driver in the procedure as in "(7) Adjusting the CH. 0
transient driver".
Note that "SNETP DRIVER (Cyclic CH. 0)" should be selected in the "System
Properties" window.
Set the memory range for CH. 0 cyclic driver adjustment to the same value as
the memory range of the CH. 0 transient driver.
4) The "Conflict Warning" dialog box appears, but click
[Yes].
5) Click [OK].
6) The "Creating a Forced Configuration" dialog box.
Click [Yes].
This finishes the adjustment of the CH. 0 transient
driver.
4 − 24