Registering The Sscnet Communication Drivers - Mitsubishi Electric MELSEC System Q Installation Manual

4. SSCNET COMMUNICATION DRIVERS
4.4

Registering the SSCNET Communication Drivers

When using the A30BD-PCF interface board on Windows 98 to make SSCNET
communication, register the SSCNET communication drivers in the following
procedure. (The following operation is not required when using the A30BD-PCF
interface card and A10BD-PCF interface board.)
Since the A30BD-PCF interface board is not compatible with the plug and play
function of Windows 98, you need to register the SSCNET communication drivers
to Windows 98 after installing SNETP and setting up the SSCNET communication
drivers. (When reinstalling SNETP, the SSCNET communication drivers are
already registered and need not be registered again.)
Register the SSCNET communication drivers in the following procedure.
SSCNET communication driver registration
procedure
(1) Registration of fast refresh driver
(2) Registration of CH. 0 transient driver
(3) Registration of CH. 0 cyclic driver
Do you use CH.1, too?
(4) Registration of CH. 1 transient driver
(5) Registration of CH. 1 cyclic driver
(6) Adjustment of fast refresh driver
(7) Adjustment of CH. 0 transient driver
(8) Adjustment of CH. 0 cyclic driver
Do you use CH.1, too?
(9) Adjustment of CH. 1 transient driver
(10) Adjustment of CH. 1 cyclic driver
(11) Restart of personal computer
End of SSCNET communication driver
registration
NO
YES
NO
YES
4 − 13