Mitsubishi Electric MELSEC System Q Installation Manual page 91
Motion controller
Hide thumbs
Also See for MELSEC System Q:
- Structured programming manual (310 pages) ,
- Special instructions manual (316 pages) ,
- User manual (72 pages)
Table of Contents
Advertisement
5. TROUBLESHOOTING
No.
Phenomenon
Cause and remedy
Communication error "12" occurs.
The SSCNET communication driver is not set up correctly.
To perform communication over SSCNET, set up the
SSCNET communication driver.
4
To do this, refer to section 4.1 "SSCNET communication
driver setup procedure."
*1: Refer to section 3.4.6(1) to install the best SNETP.
If communication is made only with the A motion, install SW3RN-SNETP.
5 − 5
Advertisement
Table of Contents
