Fuser Errors; Fuser Heat Errors - Xerox WorkCentre 3210 Service Manual

Fuser Errors

Fuser Heat Errors

WorkCentre 3210/3220 Multifunction Printer Service Manual
Warning
Hazardous voltage is connected to the Fuser. Remove the Power Cord from
the printer before starting the procedure.
There is a Fuser thermal error.
Warning
Allow the Fuser to cool before starting the procedure.
Applicable Error Messages
Open Heat Error
Low Heat Error
Over Heat Error
Initial Actions
Check the Fuser for damage or debris.
Cycle printer power.
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL8.0.0
Thermistor, PL8.0.5
Thermostat, PL8.0.7
Halogen Lamp, PL8.0.30
Troubleshooting Procedure Table
Step Actions and Questions
Reseat the Fuser connections.
1
Does the error still occur?
Run the Fuser Temp test from EDC.
2
Does the Thermostat operate
correctly?
Error Messages and Codes
Wiring and Plug/Jack Map Reference
Map 5 - Main Controller Board
Map 7 - Power Supply
Map 8 - Left Side Harness
Power and Fuser
Yes
Go to step 2.
Go to step 3.
No
Complete.
Replace the
Thermostat
(page 8-16).
3-23