Mitsubishi QD51 Programming Manual page 664

APPENDIX
Numbers in the A00 range • • • Errors related to communication processing
H
Error code
A2A , A2B , Error in communication with the console
H H
A61 , A62 ,
H H
A73
H
A75 Memory card verification error
H
A82 Cannot be used with the specified interface.
H
A83 Time out error
H
A84 Reception error
H
A85 Communication buffer overflow
H
A91 The specification of the number of requested
H
characters is incorrect.
A92 The specification of the receive buffer size is
H
incorrect.
A93 Baud rate specification is incorrect.
H
A94 Character length specification is incorrect.
H
A95 Parity bit specification is incorrect.
H
A96 Stop bit specification is incorrect.
H
A97 The specification of the number of break
H
characters is incorrect.
AA1 A printer connected to the parallel interface is
H
faulty.
AC1 The size of an array used for a control table is
H
insufficient.
AC2 It is attempted to receive more data than the
H
number of input elements.
It is attempted to send more data than the number
of output elements.
AC4 The number of requested bytes during
H
communication is too large.
AC7 A processing code for the ZCNTL instruction is
H
incorrect.
App - 19
Meaning Corrective action
Reset the communication module.
Check the memory card size, etc.
Change the interface.
Check devices on the transmission side.
Read the reception error cause using processing
code 64 of the ZCNTL instruction and check the
error contents.
Do not send large amounts of data.
Specify the number of requested characters
correctly.
Specify the size within the range of 1024 bytes or
less.
Specify the baud rate correctly.
Specify the character length correctly.
Specify the parity bit correctly.
Specify the stop bit correctly.
Specify the number of break characters correctly.
Check the printer.
Increase the size of the array.
Receive the same amount of data as the number of
input elements. Send the same amount of data as
the number of output elements.
Specify an appropriate number of requested bytes.
Check the processing code.
MELSEC-Q
App - 19