Table of Contents
Advertisement
11 INSTRUCTIONS AND FUNCTIONS
11 - 428
• Specify the characters that actually represent the codes in %(4) to %(8) in
case of the shift in codes and in %(9) to %(13) in case of the shift out codes,
in units of bytes.
Example When the number of characters is specified as 3
%(4) (Higher byte) (Lower byte)
Shift in code
Shift out code
%(9)
Thus, in order to specify shift in codes 1B
the specification should be as shown below:
%(4)=&H241B
2nd
1st
character
character
(Higher byte) (Lower byte)
2nd
1st
character
character
, 24
and 40
,
H
H
H
%(5)=&H40
1st character
3rd character
2nd character
MELSEC-Q
(Higher byte) (Lower byte)
%(5)
3rd
character
This byte is ignored.
(Higher byte) (Lower byte)
%(10)
3rd
character
This byte is ignored.
11 - 428
Advertisement
Table of Contents
