Mitsubishi QD51 Programming Manual page 451

11 INSTRUCTIONS AND FUNCTIONS
Processing Code 7
Only applicable to
AnA/AnU/AnUSCPU
11 - 281
Writing data to extension file registers by specifying sequential addresses (direct
writing)
Control table format definition
Element position
Format 1 Format 2
%(0) • • • • • • •
%(0)
%(1)
%(2)
%(3)
%(1) %(4)
%(2) %(5)
%(3) %(6)
%(4) %(7)
• It is possible to write data to extension file registers by specifying their sequential
addresses, rather than dividing them by block numbers, using this code.
• Specify the following data for <control table>.
Format 1 control table
%(0) • • • • • •
%(1) • • • • • •
%(2) • • • • • •
%(3) • • •
%(4) • • • • • •
Item
Station number
Control table
Network number
Station number
Detailed error code
Processing code
Device number
Number of points
Specify the station number of the PLC CPU to which data is
written.
See Section 4.2.2 for the allowable specification range.
Processing code
• Specify 7.
Specify the device number of the extension file registers
expressed in sequential addresses.
Specify the number of device points to be written, including
the device specified in %(2) and %(3).
The allowable specification range is from 1 to 64 points.
MELSEC-Q
Description
Specify the station number of the PLC.
Specify a control table of format 2.
Specify the network number.
Specify the station number of the PLC.
Detailed error codes are stored here.
Specify the processing code.
Specify the device number of the
extension file registers expressed in
sequential addresses.
Specify the number of points to be written.
11 - 281