Ricoh MT-C1 Service Manual page 862

APPENDIX 1 (FOR MODEL MT)
1.3.2 AUTO CALL AND READ ITEMS
SC Calls
The SC calls are generated according to the SC level as follows. Please note that
the SC level of this copier is defined differently from the other copiers.
SC Level
Fuser unit SCs which cannot be reset
A
by customer.
SCs caused by incorrect sensor
B detection which can be reset by
turning main power switch off and on.
SCs that are not shown on the
C
operation panel.
SCs that disable only the features
D
which use the defective item.
CC Calls
There are three types of CC calls as follows.
CC Code
When paper jam is detected five times consecutively without completing any
CC 101
copy job, a CC101 is automatically generated.
When a paper jam condition is not reset for 15 minutes, CC201 is automatically
CC 201
generated.
When a cover open condition is not reset for 15 minutes, CC202 is
CC 202
automatically generated.
Alarm Calls
There are four types of Alarm Calls as follows:
Type
When the PM counter reaches 80000, a PM Alarm Call is automatically reported
PM
to the Concorde system.
Original Alarm call is generated after the specified total number of originals goes through
Count the ARDF.
When 3 SCs (Any level) occur during 1500 sheets copying, an SC Alarm Call is
SC
automatically reported to the Concorde system.
When paper jamming occurs 10 times during 1000 sheets copying, a Jam Alarm
Jam
Call is automatically reported to the Concorde system.
Definition
APPENDIX-4
SC Auto Call Condition
SC call is generated immediately
SC call is generated when SC occurs
two times within 10 copies.
SC call is not generated.
SC call is generated when SC occurs
two times within 10 copies.
Definition
Definition
30 May, 2002