Ricoh MT-C1 Service Manual page 462

B140/B246 SERIES SERVICE MODE
Before initializing the Netfile partition with SP5823 011, do the following:
6. Enter the User Tools mode and execute "Delivery Settings" to print all received
fax documents scheduled for delivery and delete them.
7. In the User Tools mode, execute Document Management> Batch Delete
Transfer Documents.
8. Execute SP5832 011 then cycle the machine off and on.
Recovery Procedure 3
If "Procedure 2" does not solve the problem, execute SP5832 001 (HDD
Formatting – All), then cycle the machine off and on.
Executing SP5832 001 erases all document and address book data stored on the
hard disks. Be sure to consult with the customer before executing this SP code.
Recovery Procedure 4
If "Recovery Procedures 1 to 3" fail to correct the problem, replace the HDD.
SC No.
953 D Scanner image setting error
The settings required for image
processing using the scanner are
not sent from the IPU.
954 D Printer image setting error
The settings required for image
processing using the printer
controller are not sent from the IPU.
955 D Memory setting error
The settings that are required for
image processing using the
memory are not sent from the IPU.
964 D Printer ready error
The print ready signal is not
generated for more than 17
seconds after the IPU received the
print start signal.
984 D Print image data transfer error
After a data transfer begins from the
controller to the engine via the PCI
bus, the transfer does not end
within 15 s.
985 D Scanned image data transmission error
After a data transfer begins from the
engine to the controller via the PCI
bus, the transfer does not end
within 3 s.
986 D Software error 1
The write parameter received by
the write module at the beginning of
the setting table is NULL.
990 D Software error 2
Symptom
4-74
Possible Cause
• Software defective
• Software defective
• Software defective
• Software defective
• Controller (SIMAC) board defective
• BICU defective
• BICU
controller disconnected
• Controller (SIMAC) board defective
• BICU defective
• BICU
controller disconnected
• Controller (SIMAC) board defective
• BICU defective
• BICU
controller disconnected
B140
15 February 2006