Ricoh MT-C1 Service Manual page 559

SERVICE PROGRAM MODE TABLES
151 Line Type Authentication Judgment
Touch [Execute].
Setting this SP classifies the telephone line where Cumin-M is connected as
either dial-up or push type, so Cumin-M can automatically distinguish the
number that connects to the outside line.
•
displayed with SP5816 152.
•
confirmation and SP5816 154 will display the telephone number for the
connection to the outside line.
152 Line Type Judgment Result
Displays a number to show the result of the execution of SP5816 151. Here is a
list of what the numbers mean.
0: Success
1: In progress (no result yet). Please wait.
2: Line abnormal
3: Cannot detect dial tone automatically
4: Line is disconnected
5: Insufficient electrical power supply
6: Line classification not supported
7: Error because fax transmission in progress – ioctl() occurred.
8: Other error occurred
9: Line classification still in progress. Please wait.
153 Selection Dial/Push
This SP displays the classification (tone or pulse) of the telephone line to the
access point for Cumin-M. The numbered displayed (0 or 1) is the result of the
execution of SP5816 151. However, this setting can also be changed manually.
[0~1/0/1]
0: Tone Dialing Phone
1: Pulse Dialing Phone
Inside Japan "2" may also be displayed:
0: Tone Dialing Phone
1: Pulse Dialing Phone 10PPS
2: Pulse Dialing Phone 20PPS
154 Outside Line/Outgoing Number
The SP sets the number that switches to PSTN for the outside connection for
Cumin-M in a system that employs a PBX (internal line).
• If the execution of SP5816 151 has succeeded and Cumin-M has connected
to the external line, this SP display is completely blank.
• If Cumin-M has connected to an internal line, then the number of the
connection to the external line is displayed.
• If Cumin-M has connected to an external line, a comma is displayed with the
number. The comma is inserted for a 2 sec. pause.
• The number setting for the external line can be entered manually (including
commas).
155 Remove Service: PPP Recognition Timeout
Sets the length of the timeout for the Cumin-M connection to its access point.
The timeout is the time from when the modem sends the ATD to when it
receives the result code.
[1~65536/60/1]
The current progress, success, or failure of this execution can be
If the execution succeeded, SP5816 153 will display the result for
5-86
15 February 2006