Ricoh MT-C1 Service Manual page 543

SERVICE PROGRAM MODE TABLES
5127 APS OFF Mode
This SP can be used to switch APS (Auto Paper Select) off when a coin lock or
pre-paid key card device is connected to the machine.
[0~1/1]
0: On
1: Off
5129 F Paper Size Selection
Sets the paper size that the machine detects when the 8 x 13 dial setting on a
paper cassette is used (LT/DLT version).
[0~2/1]
0: 8 x 13
1: 8hf x 13
2: 8qr x 13
Note: hf = 1/2, qr = 1/4
5131* Paper Size Type Selection
Selects the paper size type (for originals and copy paper). (Only needs to be
adjusted if the optional printer controller is installed)
[0~2/1]
0: JP (Japan Only)
1: NA (North America)
2: EU (Europe)
After changing the value, turn the main power switch off and on.
5141* Tray for Tab Sheets (B064 only)
Sets the height of the tabs for each paper source for tab sheets. The height of a tab is
measured from the edge of the paper to the edge of the tab.
011 Tab Height: By-pass
012 Tab Height: Tray 1
013 Tab Height: Tray 2
014 Tab Height: Tray 3
015 Tab Height: Tray 4
016 Tab Height: Tray 5
5150 Bypass Length Setting
Sets up the by-pass tray for long paper.
[0~1/1]
0: Off
1: On. Sets the tray for feeding paper up to 600 mm long.
With this SP selected on, paper jams are not detected in the paper path.
[0~152/0.1 mm]
The height of the tab is the value set for this SP
multiplied by 0.1. The default tab height then is:
130 x 0.1 = 13 mm
To change this setting, measure the height of the tab
in millimeters, multiply by 10, then input the result.
For example, if the measured height of the tab is 10
millimeters, enter "100".
5-70
15 February 2006