Pro:centric Setup - LG 43LX770M Commercial Mode Setup Manual

Pro:Centric Setup

Pro:Centric options enable you to confi gure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between fi elds.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the Pro:Centric menu option. Then,
press OK.
2. Select/highlight the Media Type fi eld and press OK on the Installer
Remote to display the drop-down list of options. Then use the Up/
Down arrow keys to select either RF or IP, as applicable.
Note: If the Media Type has already been set in the EZ-Manager
Wizard, the specifi ed value will be refl ected in this fi eld.
Note: By default, the Pro:Centric Menu initially shows RF confi guration
fi elds. When "IP" is selected as the Media Type, IP Input Type and
either IP Address and Port Number or Domain Name fi elds appear
on the screen (in place of the Data Channel fi eld).
3. Refer to the appropriate subsection(s) below to confi gure the TV's
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application (Mode) itself is an additional feature,
the appropriate Pro:Centric server confi guration must be completed
to enable TV E-Z Installation (splash screen, confi guration, and
software/fi rmware) data downloads and, if confi gured, the Pro:Centric
application download.
RF Confi guration
For TVs in Pass-through Mode or FTG Mode via CPU, if the Data Channel is left at its
default value (AUTO), the TV's Data Channel Auto Search feature will be enabled. See
Installer Menu item 119 DATA CHANNEL description on page 35 for further information.
To toggle between AUTO or MANUAL settings for the Data Channel, select/highlight the Data
Channel fi eld and press OK.
When the Data Channel fi eld is set to "MANUAL," a data entry fi eld is available on the screen,
and you can specify the RF channel number that will be used by the Pro:Centric server as its
data channel. The Data Channel value can be set from 0 (disabled) to 135.
keys on the Installer Remote to select the Data Channel data entry fi eld and press OK. You
can then use the number keys on the Installer Remote to direct enter the Data Channel, or
you can use the arrow keys to select the appropriate number(s) from the pop-up virtual key-
board displayed at the bottom of the screen. When you are done, select Enter from the virtual
keyboard, and then press OK on the Installer Remote.
Note: If the Data Channel has already been set in the Installer Menu (Installer Menu item 119)
or in the EZ-Manager Wizard, the specifi ed channel will appear in the Data Channel data entry
fi eld. If you change the Data Channel in this menu, Installer Menu item 119 will now show the
value you entered here.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
206-4292 Draft A.2
IP Environment Setup (Cont.)
PRO:CENTRIC PRO:CENTRIC
Network
Pro:Centric
Mode
Confi guration Only
Media Share
Media Type
RF
Data Channel
Pre-loaded
Apps
Update Event
* Use the arrow
^
^
AUTO
OFF
(Continued on next page)
67