Ricoh Aficio 240W Service Manual page 410

BULLETIN NUMBER:
APPLICABLE MODEL:
GESTETNER – A045
LANIER – LW310
RICOH – AFICIO 240W
SAVIN – 2400WD
SUBJECT: ROLL FEEDER & CASSETTE NOT DISPLAYED
SYMPTOM:
The roll feeder and paper cassette are not displayed on the operation panel.
CAUSES:
Please note that the following operation is normal machine specification:
Usually, the optional roll feeder and paper cassette are displayed on the operation panel when SP1960 is set
to 1, 2, 3 or 4. However, even with this SP set properly, the roll feeder and cassette are not displayed
(cannot be used) with one of the following conditions.
Case 1. The operator or engineer mistakenly changes the Tray Problem Setting (1. System Setting
Key Operator) to "Use Bypass" when the machine is operating normally and then turns the main
power Off/On.
Case 2. After SC508 (cutter error) occurs, the operator presses "Cancel" when the following message is
displayed: "Press cancel and the main power switch off then on to use other functions," and
turns the power Off/On.
NOTE: In this case, the machine automatically changes the Tray Problem Setting to "Use Bypass."
SOLUTION:
A. For Case 1:
1. Explain the Tray Problem Setting to operators (See THE TRAY PROBLEM SETTING
EXPLANATION on next page).
2. Return the Tray Problem Setting back to "Do Not Use Bypass."
3. Turn the main power switch Off/On.
B. For Case 2:
1. Do the required machine repairs
2. Return the Tray Problem Setting back to "Do Not Use Bypass."
3. Turn the main power switch Off/On.
Copyright  2004 RICOH Corporation. All rights reserved.
TECHNICAL SERVICE BULLETIN
B125 – 008 11/24/2004
3.
Page 1 of 2