Attach The Mylars To The Copier - Ricoh Aficio 240W Service Manual

TABLE INSTALLATION

Attach the Mylars to the Copier

In this procedure, you will attach the narrow mylars (x2) to the rear cover of the
copier. To attach the wide mylars (x2) to the backplate of the roll feeder, see the
section after this one.
1. If the rear cover is attached to the copier, remove it ( x 2).
2. Find the 5th space [A] from the left end of the rear cover.
3. Use a clean cloth, moist with a small quantity of alcohol, to clean this area and
the bottom edge of the cover.
4. Remove the tape from each end of one of the narrow mylars.
5. Attach one end to the top edge of the cover [B].
NOTE: The top edge must be flat and parallel to the edge of the cover. The
right edge of the mylar must be parallel to ridge [C].
6. Attach the other end of the mylar to the bottom edge of the cover [D].
7. Do this procedure again to attach the other narrow mylar to the right side of the
cover.
8. Reattach the cover to the back of the copier ( x 2).
B125
0 to –1 mm
[C]
[A]
1-48
[B]
[D]
B641I020.WMF
SM