Rev. 06/2004
Setting the Copier on the Roll Feeder or Table
[A]
Roll Feeder
1. Do not remove the shipping tape from the connectors [A] of the roll feeder [B].
This prevents damage to the connectors when the copier is put on top of the
roll feeder.
CAUTION
The copy machine weighs 231 lb. (105 kg). Two or more customer
engineers are necessary to lift the copier and set it on the roll feeder or
table. There are two handles in recesses on each side of the copier. To
prevent injury or damage to the machine, always use these handles to
lift the copier.
2. Lift the machine, and set its rubber feet [D] into the holes [E] on the top of the
roll feeder [B] or table [F].
NOTE: With one person at each end of the machine, use the two handles [C]
on each end of the machine to lift it.
3. Make sure that you put the rubber feet of the copier into the holes on top of the
roll feeder or table.
⇒
4. Check the dehumidifier switch [G]. Make sure that it is OFF. If it is ON, set it to
OFF.
SM
[C]
[G]
[B]
B641I007.WMF
COPIER INSTALLATION
[D]
[E]
Table
B662I002.WMF
1-9
[D]
[E]
[F]
B125