Scanner Jam Tables - Ricoh Aficio 240W Service Manual

Gestetner a045; lanier lw310; savin 2400wd
Hide thumbs Also See for Aficio 240W:
Table of Contents

Advertisement

4.3.2 SCANNER JAM TABLES

Scanner Ready Check Jams
These jams (DJ01~DJ08) occur if there is an original in the original feed path at
these times:
• Just after the machine power comes on
• When the machine comes back to normal operation from an energy save mode.
Code
Meaning
Original Set Sensor (A4:
DJ01
8
, 9")
1/2
Original Registration
DJ02
Sensor
DJ03
A0 (34", 36") Sensor
DJ04
A1 (22", 24") Sensor
DJ05
A2 (17", 18") Sensor
DJ06
A3 (11", 12") Sensor
DJ07
Original Exit Sensor
DJ08
30"/36" Sensor
DJ15
Original Scan Unit Open
Upper Unit Exit Cover
DJ16
Open
DJ17
Original Skewed
DJ20
Registration Sensor 1
DJ21
Registration Sensor 2
DJ22
Registration Sensor 3
DJ25
Original Exit Sensor 1
SM
Location
The original set sensor (A4: 8
P
ON.
The original registration sensor is ON.
P
The A0 (34", 36") original size sensor is
P
ON.
The A1 (22", 24") original size sensor is
P
ON.
The A2 (17", 18") original size sensor is
P
ON.
The A3 (11", 12") original size sensor is
P
ON.
P
The original exit sensor is ON.
P
The 30"/36" sensor is ON.
The original scanner unit on top of the
P
machine is open.
The upper unit is not closed, or the
P
release is not locked.
The original was not straight when it was
put in. The size of the original used for
the job was not the same as data sent
P
from the original size sensors when the
registration sensor detected the leading
edge.
The original registration sensor came on
P
before the original started to feed.
The registration sensor did not detect the
leading edge after the motor operated for
the time necessary to feed 15 mm.
P
The original scan job did not start even
after a start command was received from
the IPU because the original set sensor
switched OFF.
The original set sensor detected the
trailing edge and went OFF. But the
registration sensor did not go OFF, even
P
after the feed rollers turned for the time
necessary to feed the original 20 mm
longer than the paper length.
The original exit sensor was ON when the
P
machine started to scan the leading edge.
4-17
JAM CODE TABLES
Comments
, 9") is
1/2
B125

Advertisement

Table of Contents
loading

This manual is also suitable for:

B125

Table of Contents