3.7.5 FUSING UNIT
[C]
[A]
CAUTION
Switch the main power switch off. Then disconnect the machine from its
power source. Let the fusing unit become cool for 10 minutes or more
before you remove it.
Open the upper unit.
Paper exit unit (! 3.1.4)
Pressure roller thermistor, fusing exit sensor (! 3.7.4)
[A]: Braces (x3) ( x 2 each)
NOTE: Install the brace with attached harness clamp in the center.
[B]: Fusing unit ( x 2, x 2)
[C]: Push down the levers when you remove the fusing unit.
CAUTION
The fusing unit is heavy. Pull it out slowly.
Reinstallation
• Make sure that the upper unit is open when you install the fusing unit.
• Push down on the levers [C] while you set the fusing unit in the machine.
• Connect the color coded connectors correctly when you reconnect the fusing
unit:
Europe:
Blue ! Blue, White ! White
North America: Red ! Red, White ! White
SM
[B]
3-55
FUSING SECTION
[C]
B125R613.WMF
B125