Tools And Additional Materials As Required For Assembly - Buderus Logano GE315 Installation And Maintenance Instructions Manual

2 Installation
2.2 Tools and additional materials as
required for assembly
The following tools and additional materials are
required for the boiler assembly (the listed items
must be provided by the installer):
– Boiler tensioning tool 2.2 (
– Installation kit (Option)
– Steel hammer and wooden or rubber mallet
– Half-round bastard file
– Screwdriver (Philips and flat head)
– Flat chisel
– Spanner SW 19, 36, 13, 19, 18, 24, 27 and Allan key
SW19
– Support wedge, flat iron
– Cleaning rags and cloth
– Fine emery cloth
– Wire brush
– 3-in-1 Oil
– Solvent (petrol or solution)
– Spirit level, ruler, chalk, straight edge
– Blanking flange with vent facility (for pressure test)
2.2.1 Boiler compression tool size 2.2
Compression
Segments tool per boiler
hub
5 – 7 1
1
8 – 9
(1)
2.2.2 Boiler compression tool 2.3
(complete in toolbox)
Compression
Segments tool per boiler
hub
5 – 9 1
NOTE!
For the correct arrangement of flanges for
the compression step,
8
Fig. 1) or 2.3 ( Fig. 2)
Extension Length
pieces per (total)
boiler hub [mm]
0 1560
1 2160
(0) (2160)
Extension Length
pieces per (total)
boiler hub [mm]
3 3080
page 14.
Logano GE315 - We reserve the right to make any changes due to technical modifications
4
3
Fig. 1 Boiler compression tool size 2.2
Legend for (Fig. 1) and (Fig. 2):
1 The mating flange
2 Additional flange
3 Compression unit
(compression flange and clamping nut)
4 Pull rod
5 Extension
6 Cylindrical pin (size 2.2)
7 Wedge (size 2.3)
4
3
Fig. 2 Boiler compression tool size 2.3
5
2 1 6
5
2 1 7