Burner Installation - Buderus Logano GE315 Installation And Maintenance Instructions Manual

2.6.5 Burner installation

Close the burner door and secure with 4 screws
(M16 x 140) (Fig. 26, [5]). Tighten the screws
alternately in a cross pattern.
Cut using oxy-acetylene or drill the burner plate
(Fig. 28, [1]) on site according to the required burner
pipe diameter (max. diameter 270 mm). Drill the
burner mounting holes according to the hole pattern
of the burner connection flange.
NOTE!
As option you can obtain pre-drilled burner
plates from Buderus (accessory).
Secure the burner plate on the burner door with
screws provided (seal with sealing cords of 10 mm
diameter).
Screw the burner to the burner plate.
Cut out insulating rings according to the burner pipe
diameter (Fig. 28, [2]).
Fill the remaining gap between the thermal insulation
on the burner door and the burner blast tube (Fig. 28,
[4]) with suitably adapted insulating rings (Fig. 28,
[3]).
Connect the breather tube on the sight glass with the
burner to keep the glass free from condensation.
Fit burner according to the manufactures instructions.
Logano GE315 - We reserve the right to make any changes due to technical modifications
1
Fig. 28 Burner installation (dimensions in mm)
Installation 2
2
3
4
23