Information On The Device; Eu Declaration Of Conformity; Determined Use; About These Instructions - Buderus Logano plus GB402 Installation And Maintenance Instructions For Contractors

2

Information on the device

2.1

EU Declaration of Conformity

This product, in design and operation, conforms to the European
Directives and supplementary national requirements. Compliance is
demonstrated by the CE marking. You may request the declaration of
conformity for the product. Please refer to the contact address on the
back cover of these instructions.
Approval data
Product ID number
Table 2 Approval data
2.2

Determined use

The Logano plus GB402 is designed for conventional use as a gas
condensing boiler for DHW and central heating.
Only gas supplied by the public gas supplier can be used.
Observe the details on the data plate and the specification
( Chapter 2.7, page 8) to ensure correct use.
2.3

About these instructions

These installation and maintenance instructions contain important
information for the safe and appropriate installation, commissioning and
servicing of this gas condensing boiler.
These installation and maintenance instructions as well as the service
instructions are designed for contractors who, through their technical
training and experience, are knowledgeable in handling heating systems
and gas installations.
The following documents are available for the Logano plus GB402:
• Ower's manual
• Operating instructions, MC10 control unit
• Installation and Maintenance Instructions
• Operator's log
• Technical guide
The above documents are also available for downloading via the Buderus
website.
Please contact us with suggestions for improvement or if you notice any
errors. For contact addresses and our internet address, see the back
cover of this document.
2.4

Tools, materials and equipment

For boiler installation and maintenance you will need the following:
• Standard tools used for central heating, gas and water installation,
plus set of a metric open-ended spanners and Allen keys.
• The RC35 programming unit as a monitoring device for
commissioning, inspecting and servicing the boiler.
A PC with Buderus Logamatic ECO-Soft4000/EMS and a
service key can also be used as a monitoring device.
The following may also prove useful:
• 5 pipes (approx. R 1¼ ", approx. 900 mm long) as supports on which
to roll the boiler into place
• Cleaning blade and/or chemical cleaning agent for wet cleaning
(available as accessories)
Logano plus GB402 – 6 720 820 700 (2018/01)
CE-0085BU0332
Information on the device 2
5