SATO LC400e Series Operator's Manual page 47

3.9 TEST PRINT MODE (Cont'd)
MENU
TEST PRINT MODE
CONFIGURATION
BARCODE
HEADCHECK
MEMORY
FACTORY
TEST PRINT SIZE
XXCM
PRINT SIZE
SMALL LARGE
PRESS FEED KEY
TO STOP PRINTING
LC400e Series Operator Manual
TEST PRINT MODE
Is the initial screen of the Test Print Mode.
• CONFIGURATION: The printer's configuration settings.
• BARCODE: The printer's installed barcodes.
• HEAD CHECK: A pattern to check print head elements.
• MEMORY: Print the content in the expandable memory.
• FACTORY: A factory test label will be printed.
This menu screen only appears if CONFIGURATION, BARCODE, or HEAD CHECK
was chosen in the previous menu. The increment of measure is 1 cm (0.4").
The setting range is from 4 to 10 cm (1.57" to 3.94").
For factory test prints, this screen appears instead of the previous screen for setting
print size.
Large (104 mm, 4.09") and small (30 mm, 1.18") are the only two options.
Is a directional screen prompting action on how to terminate print activity. Press
FEED button to stop printing and press again to resume printing.
Section 3: Operation and Configuration
DESCRIPTION
Page 3-23