Table of Contents
Advertisement
Section 2: Installation
2.3 HOW TO LOAD THE MEDIA (cont'd)
4.
Release the head lock lever by turning counter clockwise.
The print head assembly will be lifted up to allow media loading.
5.
Pull out the media from the rear, pass the media under the media guide shaft, through the label sensor
assembly, underneath the print head assembly and place the leading edge of the media on top of the
platen roller. Refer to the Figure 2-3.
Note
Make sure the printed side of the media is facing upwards.
Platen roller
Label sensor assembly
6.
Slide the media guide inward so the media is prevented from moving horizontally.
7.
Adjust the label sensor assembly loosening the sensor adjust knob located on the bottom side of the
label sensor assembly and moving the assembly to the correct position. After it is correctly positioned, re-
tighten the sensor adjust knob.
Page 2-4
Media guide
Media guide shaft
Media guide
Figure 2-3, Label Loading Path
Sensor
Assembly
Sensor
Adjust
Knob
Figure 2-4, Sensor Position Adjustment
Media roll
Fan-fold media
LC400e Series Operator Manual
Advertisement
Table of Contents
Troubleshooting
