SATO LC400e Series Operator's Manual page 29

3.2 DIP SWITCH SETTINGS (Cont'd)
2-1 2-2
OFF OFF
DSW
2-1 Print method setting
2-2 Media sensor selection
2-3 Head check
2-4 Hex dump
2-5 Multi-job receive buffer
2-6 Firmware download
2-7 Protocol code
2-8 Reserved
FUNCTION
Print method setting
Media sensor selection
Head check
Hex dump
Multi-job receive buffer
Firmware download
Protocol Ccode
LC400e Series Operator Manual
DSW2 DEFAULT SETTINGS
2-3
OFF OFF
DSW2 CONFIGURATION
FUNCTION
DSW2 FUNCTION DESCRIPTIONS
DESCRIPTION
Selects between thermal transfer or direct thermal printing.
Selects between a gap or I-mark sensor.
When enabled, will check for malfunctioning head elements.
Allows hexadecimal printing of all data received to the print buffer.
Allows to continuously receive print jobs while compiling and printing other
jobs.
Places the printer in mode for downloading software into flash ROM.
Selects the command codes used for protocol control.
2-4 2-5
ON
SETTING
OFF Thermal transfer
ON Direct thermal
OFF Gap sensor
ON I-mark sensor
OFF Head check disabled
ON Head check enabled
OFF Hex dump disabled
ON Hex dump enabled
OFF Single job receive buffer
ON Multi-job receive buffer
OFF Disabled
ON Enabled
OFF Standard protocol mode
ON Non-standard protocol mode
OFF -
- -
Section 3: Operation and Configuration
2-6 2-7
OFF OFF
CONFIGURATION
2-8
OFF
Page 3-5