Section 1: Introduction
1.3 PARTS IDENTIFICATION (cont'd)
Back view
Optional interface module
(IEEE1284, RS-232C, USB (Type B) or LAN)
EXT connector (External signal
interface)
Interface connector for external signals.
Connect the optional device to this terminal.
Power switch
Press this switch to turn the power on (I) or
off (O).
Page 1-4
FUSE (T3.15A 250V) holder
Used to hold a fuse which protects the printer
from unstable power supply surge. Use fuse
with rating, T3.15A 250V only.
AC input terminal
Supplies power to the printer through the
inserted power cord.
Before connection, make sure that the AC
voltage of your region is in the range of AC
100-120 V / 200-240 V, 50/60 Hz.
LC400e Series Operator Manual
6
7
8
9
10