SATO LC400e Series Operator's Manual page 40

Section 3: Operation and Configuration
3.7 SERVICE MODE (Cont'd)
MENU
SERVICE MODE
GAP [ X.XV ]
INPUT [ X.XV ]
EYE [ X.XV ]
INPUT [ X.XV ]
AUTO ONLINE FEED
YES NO
FEED ON ERROR
YES NO
REPRINT W/FEED
YES NO
FORWARD / BACKFEED
DISTANCE DEFAULT
EXT 9PIN SELECET
MODE1 MODE2
EURO CODE
D5
Page 3-16
SERVICE MODE
The Service Mode allows the programming of various dimensional settings, sensor
thresholds, and language options. It is also a transitional menu screen to access the
Counter Mode.
When setting the sensor threshold, the voltage shown on the top line is the mea-
surement using media placed over the sensor. The lower line displays the value set
for the threshold.
Please refer to the detailed procedure in the Section 3.7.1 To Set the Input
Threshold Voltage Level for Gap Sensor or Section 3.7.2 To Set the Input
Threshold Voltage Level for I-mark Sensor for setting the threshold level.
DSW2-2 determines which sensor will be enabled for use. GAP will display on the
screen when Gap sensor is enabled, EYE will display when I-mark sensor is
enabled.
Allows it to be determined if the printer will feed a label when it is placed online to
make sure proper media placement for printing.
Allows it to be determined if the printer will feed a label when an error condition is
cleared.
Allows it to be determined if the printer will print the last label in memory when the
FEED button is pressed in the normal, online mode.
Allows the selection of whether to accept the default setting or to set the backfeed
distance other than the default setting.
This display will only appear when Backfeed is enabled (DSW 3-4 = OFF).
Allows selection of the conditions that regulates Pin-9 of the EXT connector.
MODE1 enables Pin-9 when the printer goes online and a print quantity is dis-
played. MODE2 enables Pin-9 when the printer goes online without consideration of
print quantity.
Allows the hexadecimal value to be specified for the character replaced with the
Euro Character.
The default is D5 Hex.
DESCRIPTION
LC400e Series Operator Manual