SATO LC400e Series Operator's Manual page 4

Safety Precautions
Do not operate with wet hands
• Do not operate the power
switch, connect the power
cord or disconnect the power
cord with wet hands. Doing so
increases the risk of electric
shock.
Using the head cleaning fluid
• Use of flame or heat around
the head cleaning fluid is
prohibited. Absolutely do not
heat it or subject it to flames.
• Keep the fluid out of reach of
children to prevent them from
accidentally drinking it. If a
child accidentally drinks the
fluid, immediately consult with
a physician.
Do not place in areas with high
humidity
• Do not place the printer in
areas with high humidity or
where condensation forms. If
condensation forms,
immediately turn off the power
switch and do not use the
printer until it dries. Using the
printer while condensation is
on it could result in electric
shock.
Carrying the Printer
• When moving the printer,
always unplug the power cord
from the outlet and check to
make sure all external wires
are disconnected before
moving it. Moving the printer
with the wires still connected
could damage the cords or
connecting wires and result in
a fire or electrical shock.
• Do not carry the printer with
paper loaded in it. The paper
could fall out and cause an
injury.
• When setting the printer on the
floor or a stand, make sure not
to get your fingers or hands
pinched under the printer feet.
Page ii
Warning
Print head
• The print head is hot after
printing. Be careful not to get
burned when replacing media
or cleaning immediately after
printing.
• Touching the edge of the print
head with bare hands could
result in injury. Be careful not
to become injured when
replacing media or cleaning.
Caution
Power cord
• Keep the power cord away
from hot devices. Getting the
power cord close to hot
devices could cause the cord's
covering to melt and cause a
fire or electrical shock.
• When unplugging the power
cord from the outlet, be sure to
hold it by the plug. Pulling it by
the cord could expose or
break the core wires and
cause a fire or electric shock.
• The power cord set that
comes with the printer is
especially made for this
printer. Do not use it with any
other electrical devices.
Top cover
• Be careful not to get your
fingers pinched when opening
or closing the top cover. Also
be careful the top cover does
not slip off and drop.
Regarding the cutter
• Do not touch the cutter with
your hands or do not put
something into the cutter.
Doing so could result in an
injury.
Do not use in hazardous locations
• The printer is not explosion
proof certified.
• Do not use in a potentially
explosive environment or
atmosphere.
Loading media
• When loading media roll, be
careful not to get your fingers
pinched between the media
roll and the supply unit.
When not using the printer for a long
time
• When not using the printer for
a long time, unplug the power
cord from the outlet to
maintain safety.
During maintenance and cleaning
• When maintaining and
cleaning the printer, unplug the
power cord from the outlet to
maintain safety.
LC400e Series Operator Manual