Troubleshooting; Error & Status Messages On The Control Panel - Ricoh Aficio CL7000 Operating Instructions Manual

Error & Status Messages on the Control
Panel
This section explains what the messages that appear on the control panel mean
and what to do when a particular message appears.
❖ ❖ ❖ ❖ Messages (in alphabetical order)
Messages
Add Staples
Add Toner/Yellow/Magen-
ta/Cyan/Black
Add Toner: Cyan
Add Toner: Magenta
Add Toner: Yellow
Calibrating...
Call Service: EC Power Off On
If Error Reoccur Call Service
Cannot check Signal in Ad hoc An attempt to check the radio
Change Setting Tray #
Tray Paper Size:
Paper Type:

4. Troubleshooting

Description
The stapler is out of staples.
Job is not stapled.
The printer is out of the indi-
cated toner(s).
The printer is out of toner (C). Replace the toner cartridge (C).
The printer is out of toner (M). Replace the toner cartridge (M).
The printer is out of toner (Y). Replace the toner cartridge (Y).
The printer is calibrating the
color.
A communication error sent
from the engine to the control-
ler.
signal was made while the
communication mode was set
to [Ad hoc] in the interface set-
tings.
The paper size and type set-
ting in the tray differs from
that of actual paper size and
type in the tray.
Recommended Action
Replace staples.
See p.104 "Adding Staples".
Replace the toner cartridge of
the indicated color(s).
See p.4 "Replacing the Toner
Cartridge".
See p.4 "Replacing the Toner
Cartridge".
See p.4 "Replacing the Toner
Cartridge"".
See p.4 "Replacing the Toner
Cartridge".
Wait a while.
A communication error sent
from the engine to the control-
ler.
To check the radio signal , se-
lect Infrastructure in the com-
munication mode settings.
Load paper of the selected size
in the tray, and then change
the paper size setting with the
control panel. Or, press the
{ { { { Form Feed} } } } key, and then se-
lect the tray using the control
panel. Or, press the { { { { Job Re-
set} } } } key to cancel the print job.
67