Ricoh Aficio CL7000 Operating Instructions Manual page 81

Messages
Replace FuserOil Unit
soon(TypeG)
Replace Fusing Unit (Type C)
Replace Transfer Belt
Replace Waste Toner (Type E) It is time to replace the waste
Reset Develop. Unit Correctly
Yellow/Magenta/Cy-
an/Black
Reset Duplex Unit Correctly
Reset Finisher Correctly
Reset Fuser Oil Unit Correctly The fuser oil unit is not set cor-
Reset Fusing Unit Correctly
Error & Status Messages on the Control Panel
Description
The fuser oil unit should be re-
placed soon.
It is time to replace the fusing
unit.
It is time to replace the trans-
fer belt.
toner.
The indicated development
unit(s) is/are not set correctly,
or not set.
The duplex paper feed unit is
not set correctly or not set.
The finisher is not set correct-
ly, or not set.
rectly, or not set.
There is no fusing unit, or the
fusing unit is not installed cor-
rectly.
Recommended Action
Prepare to replace the fuser oil
unit. Depending on your serv-
ice contract, contact your sales
or service representative.
See p.7 "Replacing the Fuser
Oil Unit".
Replace the fusing unit. De-
pending on your service con-
tract, contact your sales or
service representative.
See p.19 "Replacing the Fus-
ing Unit".
Replace the transfer belt. De-
pending on your service con-
tract, contact your sales or
service representative.
Replace the waste toner bottle.
Depending on your service
contract, contact your sales or
service representative.
See p.25 "Replacing the Waste
Toner Bottle".
Set the indicated development
unit(s) correctly.
See p.15 "Replacing the De-
velopment Unit".
Remove and re-install the du-
plex paper feed unit. If the er-
ror continues, contact your
sales or service representative.
See "Duplex Unit Type 7100",
Setup Guide.
Turn the power off, and then
on. Remove and re-install the
finisher correctly. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
See p.2 "Detaching and Reat-
taching the Options".
Set the fuser oil unit correctly.
See p.7 "Replacing the Fuser
Oil Unit".
Set the fusing unit correctly.
See p.19 "Replacing the Fus-
ing Unit".
4
75