Selecting And Checking The Target/Calibration Channel - Konica Minolta CHROMA METER Instruction Manual

Selecting and Checking the Target/Calibration Channel

You can select or check the measured values being stored by following the procedure
below. (This function is intended for selecting or checking the values stored for [Target] or
[User Calibr.].)
Operating Procedure 1
INFO key: Press this key and you can check the measurement
Operating Procedure 2
1.
While the measurement screen is
displayed, press the MENU key.
The setting screen is displayed on the LCD
screen.
2.
Press the RIGHT key or LEFT key to display the [Target] or [User
Calibr.] screen.
3.
Press the UP key or DOWN key to
select [Sel. Targ.] or [Calib. Ch.] and
then press the ENTER key.
condition or the target/user calibration value being used.
5, 6
1
80
3, 5
3, 4
2, 4
INFO key