Oil Pump - Husqvarna TE 250-310 2012 I.E. Workshop Manual

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
Workshop Manual Ed. 12-2011
ENGINE OVERHAUL
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA

Oil pump

Loosen the screws (1) using a 4 mm Allen wrench and remove pump body (2)
and gasket.
Remove the pump rotors (3) and (4), and extract the drive pin (5) to release
the gear (6).
Check gear (6) and rotors (4) for wear. Replace if worn.
Smear the rotors with oil and make sure to align the rotor dots (9)
on assembly. Use a new gasket.
G.18