Husqvarna TE 250-310 2012 I.E. Workshop Manual page 159

ENGINE OVERHAUL
TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
1- Pressure plate, 2- Clutch actuator plate, 3- Pushrod, 4- Piston assembly: Check these parts for signs of wear or failure. If
any are found, replace the part.
5- Clutch hub: Check the steel plate slots for signs of wear or failure. If any are found, replace the part.
6- Clutch housing: Check the friction plate slots for signs of wear or failure.
Check the needle roller bearing seats for signs of wear. If any are found, replace the part.
7- Primary drive gear pair: Check gear teeth for signs of wear or failure. If any are found, replace the part.
Workshop Manual Ed. 12-2011
G.17