Husqvarna TE 250-310 2012 I.E. Workshop Manual page 208

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
6a
6a
5
6a
7
8
Workshop Manual Ed. 12-2011
ENGINE REASSEMBLY
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
TE-TXC:
TE-TXC
Refit the four shim (5) on the valves and the valve buckets (6) as marked on
removal.
H11059
TC
TC:
5
Lift the rocker arms (6a) and refit the four pads (5) following the numbering you
marked during the removal.
6a
5
5
H11060
TE-TXC:
Check the bearings of the timing drive upper gear (7) and replace them if
needed.
TE-TXC
Refit the gear (7) with its shaft (8) and gasket (9).
TC:
H11061
TC
H11062
The gear (7) requires no timing.
Grease the O-Ring (10) before refitting the shaft (11). Check the
status of the gasket (10) and if it shows damages, replace it.
11
10
H.46
TC
H11063