Husqvarna TE 250-310 2012 I.E. Workshop Manual page 240

TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
Workshop Manual Ed. 12-2011
FRONT SUSPENSION
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
Push down the inner tube.
Slip the tool shown in the figure between wheel axle carrier and cartridge nut.
Insert the rebound adjuster rod into the piston rod and tighten the adjuster
screw.
Be careful not to hurt your fingers.
H06852
Tighten the adjuster screw all the way in.
Make sure that there is some play between the bottom edge of the adjuster screw
and the upper edge of the nut.
H06853
Tighten nut and adjuster to 28 Nm (20.6 ft/lb) using a wrench.
H06854
I.16