Advanced - TP-Link TD-W8960N User Manual

4.5.6

Advanced

Go to Wireless → Advanced, you will see the screen of Wireless Advanced settings shown as
below.
Channel: Select the channel you want to use from the drop-down List. This field determines

which operating frequency will be used. It is not necessary to change the wireless channel
unless you notice interference problems with another nearby access point.
Mode: In the drop-down list you can select 11b, 11g, 11bg, 11bgn and 11n only. "11bgn"

allows both 802.11b, 802.11g and 802.11n wireless stations to connect to the router.
Bandwidth: Select the Bandwidth you want to use from the drop-down List. If bigger

bandwidth is selected, device could transmit and receive data with higher speed.
Fragmentation Threshold: This value specifies the maximum size for a packet before data

is fragmented into multiple packets. If you experience a high packet error rate, you may
slightly increase the Fragmentation Threshold. Setting the Fragmentation Threshold too low
may result in poor network performance. Only minor reduction of the default value is
recommended. In most cases, it should remain at its default value of 2346.
RTS Threshold: Should you encounter inconsistent data flow, only minor reduction of the

default value 2347 is recommended. If a network packet is smaller than the preset RTS
threshold size, the RTS/CTS mechanism will not be enabled. The router sends Request to
Send (RTS) frames to a particular receiving station and negotiates the sending of a data
frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS)
frame to acknowledge the right to begin transmission. This mechanism can provide you a
quiet communication channel by notifying other stations not to send packet for a period of
time. In most cases, keep its default value of 2347.
DTIM Interval: This value, between 1 and 255, indicates the interval of the Delivery Traffic

Indication Message (DTIM). A DTIM field is a countdown field informing clients of the next
window for listening to broadcast and multicast messages. The countdown unit is measured
by the amounts of beacon frames received. When the router has buffered broadcast or
multicast messages for associated clients, it sends the next DTIM with a DTIM Interval value.
Its clients hear the beacons and awaken to receive the broadcast and multicast messages.
The default value is 1.
65
TD-W8960N User Guide