TP-Link TD-W8960N User Manual page 41

2. Then you will see the next screen as shown below.
3. Enter the Filter name
4. Select the protocol
and Destination IP address.
5. Enter a Source IP Address
or port: port) in the text boxes separately.
6. Enter a Destination IP Address
Port (port or port: port) in the text boxes separately.
7. Select one or more WAN/LAN interfaces displayed to apply this rule.
8. Click Save/Apply

Note:
When you add an IP Filtering entry, you must configure at least one condition on the preceding screen
except the Filter name. If you leave the Protocol blank, it means that the rule is effective to all
protocols, if you leave the Source IP Address and/or Destination IP Address blank, it suggests that all
Source IP Addresses and/or Destination IP Addresses are controlled by the rule, if you leave the
Source Port and/or Destination Port blank, it suggests that all Source Ports and/or Destination Ports
are controlled by the rule.
4.3.6.2 MAC Filtering
Go to Advanced Setup
section allows you to control access to the internet by users on your local network based on their
MAC Address.

Note:
MAC Filtering is only effective on ATM PVC(s) configured in Bridge mode.
for the rule, it is exclusive and must be filled.
in the drop-down list for the connection between the Source IP address
in dotted-decimal notation format and then type
in dotted-decimal notation format and then type
to save this entry.
→ Security → MAC Filtering, you can configure MAC Filtering rules. The
34
TD-W8960N User Guide
Source Port
Destination
(port