TP-Link TD-W8960N User Manual page 36

Remove: Select the checkbox in the table and then click Remove, then the corresponding

entry will be deleted in the table.
To add a virtual server entry:
1. Click Add and then you will see the new Virtual Server in the next screen.
2. Select the Interface which you want to use from the drop-down list.
3. Select the service which you want to use from the drop-down list. If the list does not have the
service you need, type the name of the custom service in the text box.
4. Type the IP Address of the computer in the
5. Enter the External Port Start, External Port End, Internal Port Start and Internal Port End in
the table, and then select the protocol used for this Virtual Server, TCP,
6. Click Save/Apply

Note:
If you select the service from the drop-down list, the External Port Start, External Port End, Internal
Port Start, Internal Port End and the Protocol will be added in the table automatically. You only need to
enter the Server IP Address for the Virtual Server.
4.3.5.2 Port Triggering
Go to Advanced Setup
Some applications require that specific ports in the router's firewall should be opened for access
by remote devices. Port Trigger dynamically opens up the 'Open Ports' in the firewall when an
to enable virtual server and then you will see your setting.
→ NAT → Port Triggering, you can set Port Triggering on the screen.
Server IP Address text box.
29
TD-W8960N User Guide
UDP or All.