Layer2 Interface - TP-Link TD-W8960N User Manual

This Advanced Setup section mainly introduces how to configure the router for adequate use. The
detailed explanations for each subsection are provided below.

Note:
To completely configure the WAN Interface, you need to first select the Layer2 Interface
Interface) according to the connection ISP provides for you, and then to select the type of the
connection (4.3.2 WAN
4.3.1

Layer2 Interface

Go to Advanced Setup
interface) over ATM Interface
ATM Interface: Configure the router to access internet as an ADSL user. ISP provides you

VPI (Virtual Path Identifier), VCI (Virtual Channel Identifier) settings and the DSL Interface
with RJ11 connector.
ETH Interface: Configure the router to access internet as an Ethernet user. ISP provides you

Broadband Internet Service and the Ethernet Interface with RJ45 connector.
4.3.1.1 ATM Interface
Go to Advanced Setup
on the screen below.
Service) for the further configuration.
→ Layer2 Interface, and you can select WAN Service Interface (layer2
or ETH Interface.
→ Layer2 Interface → ATM Interface, you can Configure ATM interfaces
13
TD-W8960N User Guide
(4.3.1 Layer2