TP-Link TD-W8960N Quick Installation Manual

Quick Installation Guide
300Mbps Wireless N ADSL2+ Modem Router
TD-W8960N
Connecting the Hardware
If you don't need the phone service, just skip step 1 and directly connect
the modem router to the phone jack with a phone cable, then follow steps
3 and 4 to complete the hardware connection.
Phone Jack
1
Connect the ADSL splitter
to the phone jack.
ADSL Splitter
Modem Router
2
Connect the modem router to the
ADSL splitter.
3
Push in this button to turn on the modem router and
the Power LED lights up.
4
Verify that the hardware connection
is correct by checking these LEDs.
Power ADSL
Wi-Fi
On On On
Notes:
1) The ADSL LED takes about 1 to 2 minutes to stabilize.
2) If the Wi-Fi LED is off, please press the WiFi button on
the rear panel for 2 seconds, then check the LEDs again
in a few seconds.
Power Adapter