Multicast - TP-Link TD-W8960N User Manual

Click Add, and you can configure the 6in4 tunnel on the next screen as shown below.
Mechanism: DS-Lite, this type is used in the situation that your WAN connection is IPv6 while

LAN connection is IPv4.
Associated WAN Interface: Select a WAN connection from the drop-down list. Only the

connected WAN connections can be shown in the drop-down list.
Associated LAN Interface: Select a LAN connection from the drop-down list. Only the

connected LAN connections can be shown in the drop-down list.
AFTR: Enter the IPv6 address of the remote node.

Click Save/Apply to make the configuration take effect.

Note:
In this type, there should not be any IPv4 WAN connections. If there are IPv4 WAN connections, the
page will prompt you to delete all the IPv4 WAN connections.

4.3.15 Multicast

Go to Advanced Setup
Click Save/Apply to make the settings effective.
→ Multicast, you can configure the IGMP protocol on the screen.
48
TD-W8960N User Guide