Vlan; General - Siemens SCALANCE XB-200 Configuration Manual

Configuring with Web Based Management
5.5 The "Layer 2" menu
Steps in configuration
1. Enter the relevant values in the columns "Total Ingress Rate"and "Egress Rate" in the
row of the port being configured.
2. To use the limitation for the incoming frames, select the check box in the row. For
outgoing frames, the value in the "Egress Rate" column is used.
3. Click the "Set Values" button.
5.5.4

VLAN

5.5.4.1

General

VLAN configuration page
On this page you specify whether or not the device forwards frames with VLAN tags
transparently (IEEE 802.1D/VLAN-unaware mode) or takes VLAN information into account
(IEEE 802.1Q/VLAN-aware mode). If the device is in the "802.1Q VLAN Bridge" mode, you
can define VLANs and specify the use of the ports .
The possible settings on this page depend on what you select in the "Base Bridge Mode"
box.
Note
Changing the Agent VLAN ID
If the configuration PC is connected directly to the device via Ethernet and you change the
agent VLAN ID, the device is no longer reachable via Ethernet following the change.
180
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04