Siemens SCALANCE XB-200 Configuration Manual page 163

● Custom Maximum Power [W]
Enter the maximum power that a port makes available to supply a connected device.
This value is only taken into account when the "Use Custom Maximum Power" check box
is selected.
The user-defined power is compared to the range of values of the class indicated by the
connected device.
– If the user-defined power is within the class of the connected device, the user-defined
– If the user-defined power is above the class of the connected device, the highest value
– If the user-defined power is below the class of the connected device, the lowest value
If the power consumption of the connected device exceeds the defined or used maximum
power, the connected device is turned off.
● Classification (read-only)
The classification specifies the class of the device.
● Status (read-only)
Shows the current status of the port.
The following states are possible:
– disabled
– delivering
– searching
Note
If a device is connected to a port with PoE capability, a check is made to determine
whether the power of the port is adequate for the connected device.
If the power of the port is inadequate, although PoE is enabled in "Setting", the port
nevertheless has the status "disabled". This means that the port was disabled by the PoE
power management.
● Power [mW] (read-only)
Shows the power that the SCALANCE provides for this port.
● Voltage [V] (read-only)
Shows the voltage applied to this port.
● Current [mA] (read-only)
Shows the current with which a device connected to this port is supplied.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
value is used.
of the class is used.
of the class is used.
The PoE power supply is deactivated for this port.
The PoE power supply is activated for this port and a device is connected.
The PoE power supply is activated for this port but there is no device connected.
Configuring with Web Based Management
5.4 The "System" menu
163