Siemens SINUMERIK 840Di sl Operating Manual page 74

2
Operator Components/Operating Sequences
2.7 Job list
2-74
COPY [source] [destination]
The COPY instruction copies one or several files from the HMI to an
NC working memory. The original files remain stored on the HMI.
The COPY instruction is executed only if the relevant file does not yet
exist at the destination or if it has a different time stamp.
This instruction is recommended for an m:n link.
If this type of file needs to be modified, it must always be edited on the
NC. If the file has been distributed more than once via the job list, and
you want the changes to be active in all NCs, you must first unload
that file, then edit it, and finally redistribute it via the job list.
[source] is [path]/[name]
[destination] is the NCU/channel address:
The destination can be specified using one of the three address
categories. Only the logical name from the NETNAMES.INI file is
taken into account.
NC= Name of the NCU
Without NETNAMES.INI, it is only possible to specify the NC
name with NC=.
CG= Name of the channel group, i.e., copy in every channel of this
group (therefore in all NCs to which the channels are
assigned).
Parameter CG can be specified only if a channel menu is
configured.
CH= Name of channel
Channel names are only uniquely assigned across all NCs, if
a channel menu is configured.
If no destination is specified, the source is copied to the NC currently
linked to the HMI. If * is entered as the destination, the source is
distributed to all the NCs configured in NETNAMES.INI.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
2
01/2008
© S iemens AG 2008 All rights reserved.