Siemens SINUMERIK 840Di sl Operating Manual page 319

6
01/2008
"Details..." menu
Standard vertical
Tool paths Tool paths
or
on/off on/off
Fit to
size
Zoom...
<<
Menu "Details...."
3D vertical
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
• "Top view" or "top view and front view" for
milling
• "Wire model" (3D without tool data) for milling
• All views for turning
Activate/deactivate representation of the tool center point path.
Deactivation also deletes any tool paths from the current model that
have already been stored (default setting: tool paths on).
With 2 window views only: Select active window.
Possible in the same manner with "TAB" or "NEXT WINDOW
(V06.02.13 and higher).
Front
Conditionally with 2 window views:
view...
"Front..." depending on type of view active (horizontal selection) same
meaning as "from above..." or "from left..."
Conditionally with 2 window views:
Rear
"Rear..." depending on type of view active (horizontal selection) same
view...
meaning as "from below..." or "from right..."
Automatic screen resizing
relative to the window activated with
Also possible with the "ENTER" or "INPUT" key.
Show window pane border in active window
(Size can be altered with "+" - and "-" keys, position can be altered
with cursor keys.)
Return to main simulation menu
"3D view" (3D with tool data) for milling, not effective for turning
simulation
Standard 3D view, orientation top/front
3D view, orientation top/left, rotated clockwise by 90 °.
3D view, orientation top/right, rotated clockwise by 90 °.
3D view, orientation bottom/front, inclined towards top
"Program" operating area
6.8 Program simulation
.
6
6-319