Siemens SINUMERIK 840Di sl Operating Manual page 186

5
Parameters operating area
5.3 Tool management
Unload
Relocate
Working
offset
Tool
catalog
Tool
cabinet
Trans-
formation
Special feature:
(Names assigned by
user)
Magazine
list 1
Magazine
list 2
Magazine
list 3
5-186
The tool is deleted from the current magazine location.
The tool is moved from the current magazine location to another
location.
The cutting edges of active replacement tools are displayed. They are
sorted in order of ascending D numbers.
Further softkeys are displayed when you press the "ETC." key:
You can create new tool master data ("ideal" tools) and edit the
existing data.
You can create new tool offset data and tool operating data ("real"
tools) and edit the existing data.
This softkey allows you to display the tool data as transformed data
(adapter data are calculated) or non-transformed data.
This conversion feature is only available in the magazine list display.
The data are always displayed as non-transformed data in the tool list
and as transformed data in the working offset list.
If you display transformed data and want to create a new tool in the
magazine list (loading mode), the transformed data display is
activated exclusively for input of this data block.
Vertical softkeys (magazine list)
Selection of user-specific display windows (if configured), e.g.,
• General data
• Geometry data
• Wear data
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.