Siemens SINUMERIK 840Di sl Operating Manual page 164

5
Parameters operating area
5.1 Tool data
Required offset values of
a surface grinding wheel
without base dimension
for GWPS
Required offset values of a
facing wheel with
monitoring parameters
5-164
STC_TPG1
STC_TPG2
STC_TPG3
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG9
F: Toolholder reference point
Other values must
be set to zero
G17:
Radius in X/Y
G18:
Radius in Z/X
G19:
Radius in Y/Z
STC_TPG1
STC_TPG2
STC_TPG3
STC_TPG4
STC_TPG5
STC_TPG6
STC_TPG7
STC_TPG8
STC_TPG9
Other values must
e.g.
be set to zero
X
G17:
Radius in X/Y
G18:
Radius in Z/X
G19:
Radius in Y/Z
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
01/2008
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
F'
Base
Minimum wheel radius
Minimum wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
F: Toolholder reference point
© S iemens AG 2008 All rights reserved.
5