Siemens SINUMERIK 840Di sl Operating Manual page 205

5
01/2008
Magazine
list
Tool list
Unload
Tool in
cabinet
Data on CC
in cabinet
From
magazine
Delete tool
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
Select the appropriate list via softkey:
• "Magazine list"
A tool is to be physically removed from a magazine location. You
can configure whether the corresponding NC block is also removed
from the TO memory.
Select the magazine and the tool to be unloaded (select the tool
with the cursor).
or
• "Tool list"
The NC block is to be unloaded from the memory. Select the tool
to be unloaded (select the tool with the cursor).
Select the "Unload" softkey.
The vertical softkey bar changes.
The tool data of the selected tool are stored in the tool cabinet on the
hard disk. This allows you to load the tool with the same data again at
a later point.
If a code carrier is installed, the tool data are automatically stored
there. This allows you to load the tool with the same data again at a
later point.
The selected tool is unloaded.
The corresponding line is deleted from the magazine list.
The entries in the magazine number and location number columns are
removed from the tool list.
"Unload directly from spindle" is only possible if the buffer is selected
and the cursor is positioned on the location of the spindle.
To exit the screen without unloading the tool, select another display
in the vertical softkey bar before pressing "Start".
The tool data of the selected tool are deleted from the TO memory. If
the tool is in a magazine location, it is unloaded and deleted.
If a host computer is connected, the data are transferred to the host
computer each time a tool is deleted or unloaded.
Parameters operating area
5.3 Tool management
5
5-205