Siemens SINUMERIK 840Di sl Operating Manual page 212

5
Parameters operating area
5.3 Tool management
Display/edit tool data
Offsets
Cut. edge
user data
Tool user
data
Abort
OK
Additional functions
Delete
5-212
The vertical softkeys can be used to display and edit the data for tools
already stored in the cabinet:
• Tool offset data (cutting edge data)
Enter the required offset values. The design of the vertical softkeys
is identical to the tool catalog softkeys (see previous section under
offsets).
A new cutting edge can be added to a tool at any time (even if the tool
is already located in the magazine).
• Cutting edge user data (if configured)
Up to 10 user-specific cutting edge data entries are displayed here.
Enter the required settings in the table.
• Tool user data (if configured)
Up to 10 user-specific tool data entries are displayed here. Enter
the required settings in the table.
• Select "Abort" to discard the settings.
The data retain their old values.
• Press "OK" to accept the changes.
The data are updated.
The "Delete" function is also available in the tool cabinet. It is not
possible to copy or create a new ideal tool here (only in the tool
catalog).
The currently selected tool is deleted from the tool cabinet after a
prompt.
All data of the tool with this Duplo number are lost. The master data in
the tool catalog are not affected (tool with Duplo number 0).
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
5
01/2008
© Siemens AG 2008 All rights reserved.